webertherm anc
Insulation fastener
- Make sure not to damage the thermal insulation layer or substrate during fixing of the anchor
- Make sure that the depth of drilling is greater than 35mm and the anchoring depth inside the substrate is min. 25mm
- The sleeve on top of anchor should not protrude out of the surface of the thermal insulation layer The anchor is made of PVC sleeve. It can be applied on the wall such as clay brick, hollow blocs, normal concrete, concrete blocks
Surface of application
Wall
Suitable for all the above substrate • High pull-off strength for a higher security of the system • Low thermal conduction value to avoid thermal bridge Approved for concrete, solid and perforated masonry • Precise installation due to defined anchor washer movement through movable washer • The flexible anchor washer assures an optimum positioning in the insulation board, also in case of slightly sloped drilled boreholes • Plastic injection element to reduce thermal transmission • Short embedment depths, minimum drill hole depth • Minimised risk of breaking nails due to fibrereinforced composites • Can be used with an additional spreader washer • Premounted nail for quick installation
The substrate should be sound, dry, flat, clean and durable