weberfloor 4832
Solvent-free,single component Polymer adhesive for the installation of parquet and wood floors.
weberfloor 4832 is a factory-mixed, 1-component, ready-to-use and solvent-free STP (silane-terminated prepolymers) parquet adhesive.
- Self-levelling
- High adhesion
- Eco-friendly
- Fast-setting
- Chemical resistance
- Easy to apply
- Abrasion resistance
- Mechanical resistance
Surface of application
Floor
Jordan | Lebanon | UAE | KSA | Oman | Qatar | Kuwait |
---|---|---|---|---|---|---|
16 kg | 16 kg | 16 kg | 16 kg | 16 kg | 16 kg | 16 kg |
Easy to apply Solvent-free No discoloration even in thin coatings Suitable for hotel luggage's carrier Excellent initial adhesion EMICODE EC1 PLUS: very low emission Excellent Tack and Bonding Excellent Adhesion and high Strength Water Resistant Non Toxic and Non Flammable Antifungal
- The adhesive must be stirred before use and then applied and spread evenly with a toothed spatula.
- Adhesive cavities are to be avoided. B3 or B11 toothing in dependence on the parquet used Locations.
- The toothing to be used is specified by the parquet manufacturer.
- Between wall and parquet wedges at joints of about 10-15 mm must be used upon laying.
- The wedges must be removed immediately after laying.
- The wood flooring is lodged in the adhesive bed and full surface, to obtain a good wetting of the backsides of the coatings Only as much adhesive shall be applied as can be covered within the laying time.
- It is essential to ensure good contact between the floor covering and the adhesive.
- Bonding over existing floor coverings should be avoided.
- Clean any excess of adhesive using water immediately.
- Do not allow the adhesive to dry, after complete dryness of the adhesive ridges, covering laying is no longer possible. Make sure to Avoid any holes after spreading the product.